It looks like you're new here. If you want to get involved, click one of these buttons!
- Last Active
- January 2010
Just itchin to drive but having tranni problems 57 Ford Custom 300Thank you again for your reply. There is a decent amount of play/slop when the torque convertor is put into the transmission. Once it bottoms out inside of the yoke, I can push it in about 1/2 an inch on top and on bottom. There is some new scarrin…
Just itchin to drive but having tranni problems 57 Ford Custom 300Thank you for your reply. I still have the trans out. The flywheel is actually bolted to and completes the torque convertor. The torque convertor along with the flywheel are then bolted to the drive plate( I am unsure if this is the correct name for…
Stuck Pinion Bolt on a 57 Custom 300Hi, Thank you for your reply. Yes I am talking about the nut on the spidle shaft bolt that the yolk slides over. There are no visible welds. I tried heat but maybe not for long enough. Is there anything damageable when I heat the nut? How lo…
Should I swap engines??Thanks for the input, but after getting the engine out and ungunked, we found that it was a 272 block. Not only that, but after dropping the pistons, one of the cylinders has taken a pretty good beating, looks like a piece of metal got in and was st…