Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,062
- Orphaned Marques
- ↳ Hudson21,132
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
Looking for trim piece for coupe
-
I am looking for DRIVER's side door belt trim for '52-54 5,6,7, series step down. Passenger side is outlined in picture.
-
I believe I have those up in the attic. Let me look.
-
Have you checked with Hudzilla?
-
Ken u-tex - thanks. I've called Hudzilla.
-
So Hudzilla has the part?
-
I have not heard yet from Hudzilla. Ken, if you have one, I am interested.
-
i got one if needed also, russmaas@frontier.com
-
I thought I had two from the doors, but it turns out I have three sets of the longer pieces that run from the back of the doors and meet at center of rear window of the coupe. I have the door pieces, but they are still attached to the two spare '52-'53 coupe doors I have (right and left). If Russ has one already to go, then he would be your better bet.
-
Russ, sent you a message.
-
I need the middle piece (not this higher piece mentioned here) that goes on the doors of a 52 or 53 Hornet coupe or Hollywood, any of ya'll have these? thanks!
-
v george: Right, or left?
-
I just looked at my car and I need both, my right is missing and left has screw-holes in it, these are 49 1/4 inches long x 1 7/16 inches wide, thank you
-
'54s will work as well, and you can modify front spears to fit, all Hornets 52-54 had same front spear.
