Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,047
- Orphaned Marques
- ↳ Hudson21,118
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors148
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Geoff C., N.Z. December 2012
- kamzack December 2012
- walts garage-53 December 2012
hudson 8 valve lash ?
-
Lookin for the valve clearance on a 51 str8 8?
-
I'd suggest sending an email to Dr. Doug at Wildrick Restorations Address is on his website.
Kim -
.008" inlet and .010 exhaust, with engine hot.If you're stuck in a hole, stop digging.
-
Make sure you use a new gauge after you set 4 valves for then they are pounded out of shape and you will have tight valves. Best way is cold set at 12 and 14. Walt.
