Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,223
- Orphaned Marques
- ↳ Hudson21,261
- ↳ Street Rods808
- ↳ Off Topic569
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash71
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company959
- ↳ Chrysler Corporation478
- ↳ GM Corporation1,397
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,967
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Geoff C., N.Z. November 2012
- harry54 November 2012
- HornetSpecial November 2012
- Oldfarmer1947gmailcom November 2012
- RonS November 2012
- Tallent R November 2012
amp light 54 hornet
-
My amp light is acting strange. Sometimes it comes on like the generator is discharging . Then sometimes it acts normal. Generator rebuilt a few years ago so i don't think its that . Do you think that its the regulator ?
-
Dont rule out connecting wires to the generator. The combination of old wires and engine movement can break the wire inside where you cant see it. Will cause just what you describe,
RogerRetired Tech. -
wires to the generator are relativlely new... i cleaned battery and connections to the regulator.. didn't help though
-
I had same problem and it turned out to be regulator. Change that out and see what happens I had my generator redone before I checked regulator. Bad move.
-
Long shot: when stepdown Hudsons were new, Hudson put out a service bulletin thar told service managers to check all in coming service jobs for TOO long screws in the voltage regulators. Seems some got the long screws during manufacture and over time those screws wore through the paint on fender wells creating intermittent shorts.Oldfarmer1947@gmail.com
-
thanks i will check...
-
Harry, check the ground on the regulator. Take a wire with clips and clip one end to the regulator base and the other to the battery ground post ( pos if original on pre 56s), leave it in place and observe. If solved, clean the holes and mounting screws for the regulator.
-
Also, run a folded piece of 400 grit sandpaper between the points inside the regulator. Most likely a bit of burning on the voltage coil points. there are three coils, the cut-out, current, and voltage coils. The voltage coil is the one at the opposite end to the very heavy wired cut-out. Clean the points with sandpaper, and then with a piece of plain paper soaked in meths, or isopropyl alcohol to remove any residue.If you're stuck in a hole, stop digging.
-
thanks
