Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,028
- Orphaned Marques
- ↳ Hudson21,100
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors148
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,958
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- ernie28 September 2012
- Marconi September 2012
- MikeWA September 2012
- Pacemaker500 September 2012
O/D Kickdown Switch ???
-
Is the O/D Kickdown switch supposed to have a solid, definite "click" to it?
If so, from whom in the Club do I purchase a new one? -
No click, it connects one pair of terminals in the released position and the other pair in the depressed position, it does not 'click'. You can check it with a powered test lamp.
-
Hi PM500
The Overdrive section of the Mechanical Procedures Manual has a piece on troubleshooting and the bit on testing the kick-down switch is very useful - speaking from experience last month! ;)
http://hetclub.org/burr/manuals/1950_hudson_mechanical_procedures_manual.pdf -
Thank you! I own the manual. I just happened to have the floor pane out to put on the heat shield and pushed the switch a few times.
Now that I have the floor back in, I will move on to reconnecting the O/D completely.
I still need to figure out the bullet tip wire end on the Governor (what is the little screw size, #4-32 TPI ???) and get the Relay hooked up. -
If you still need a kickdown switch, I have several- let me know.
