Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,062
- Orphaned Marques
- ↳ Hudson21,132
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
Key switch wiring for a 1952 Hudson Hornet
-
As far as I can tell it is as follows.
Bat= #3 wire,yellow, 12 gauge,ign feed
Ign=#9 wire, orange, 18 gauge, temp gauge/ there are two#5 wires, red,18 gauge, they go to the oil and gen lights, #13 wire black, 14 gauge, goes to coil
St= #14 wire,black 16 gauge goes to starter solenoid
Acc=#6 wire, black and red, 18 gauge, goes to the gauge voltage relay on the back of the dash between the two gauges(temp and gas). Richie.