Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,033
- Orphaned Marques
- ↳ Hudson21,105
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors148
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,958
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
Wiring harness connectors
-
Anyone have an idea how to replace the 4 pin connectors for the overdrive relay and stepdown switch on my 52 Hornet. I've bought a replacement wiring harness from Rhode island wiring. They say to re use the existing connectors,...doesn't look like the plastic connectors come apart. I don't want to have to cut and solder the wires at the connector if I don't have to.
Dave -
Dave,
I just looked at a relay connector and it is a 2 piece moulded part held together with a rivet and was the same as used on my old '50 C6. I think that I removed the rivet (very carefully) and replaced it with a 4-40 or 6-32 machine screw and nut. That was around 1980 so The memory is a bit hazy. Hope this helps.
Bruce
Bruce -
Best I remember, Bruce has it correct..Also if the O.D.connecter is weathered, the connecter the turn signal flasher plugs into is the same, so not hard to find a good one of those in a parts car, as it is ptotected under the dash..
RD -
I'd recommend Bruce's approach, just drill out the rivet, take it apart, clean the corrosion off the metal and re-bend the prongs to make the connection tight, maybe put some electrical grease on it to prevent further corrosion, then screw together (or maybe you can find the correct rivet and tool, and do it the old fashioned way.
An alternative would be to take a really good photo of the connector, note the dimensions and any other characteristics of the connector, and shoot an e-mail to some old-line suppliers, such as Northwestern Auto Supply (which no doubt has a box of these someone up in their attic with 2 inches of dust on it): http://www.northwesternautosupply.com/getParts.html .
