Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,049
- Orphaned Marques
- ↳ Hudson21,120
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors148
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
AMC fuel pump
-
I'm ready to buy the AMC single stage pump. However, I have found that there are two pumps that look almost the same. The Carter 6737 looks like the inlet will face forward when mounted on the Hudson 308 and will require another sharp bend in the inlet hose. However, there is also a Carter 60167 that looks the same except the inlet would face to the rear and would not require the sharp bend.
The problem is that I can't find any information about the 60167 (pressure, flow rate, connection sizes). Has anyone used the 60167 pump or does any one know the specifications on it?
Thanks
Ed -
Fuel pressure on the AMC pumps is around 4 1/2 to 5 psi.
-
Well, app for the 60167 pump is AMC Eagle '83 - '84, Jeep J10 '81 - '87, Wagoneer '80 - '83 and Wrangler '87 - '90. Since all these cars used the 4.2L 6 cyl. I suspect that the specs are similar to the 6737 pump.
