Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,072
- Orphaned Marques
- ↳ Hudson21,138
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,962
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Park_W August 2011
- ss6:hh308 August 2011
- walts garage-53 August 2011
'54 308 Carter Carb fuel inlet thread pattern?
-
I think it is a WGD. I removed a 1/8 inch Nation Pipe Tap. Deeper into the fuel inlet bore the undisturbed threads look not tapered and more coarse than 1/8 NPT?
Anybody know what it should be. Thanks. -
All the Hudson carbs I've seen, from '36 on up, have had a 1/8 NPT in the bowl cover.
-
Might have been cross threaded in the pot metal. I will get the magnifing glass out and try a tap to clean it up.
-
All Carter Carbs are 1/8 NPT threads on the bowl cover, 1932 to 1954. You will have to find a new cover. Need tag number to get the correct bowl cover, or the number stamped on the base where the gasket goes. I may be able to help you. Walt.
