Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,068
- Orphaned Marques
- ↳ Hudson21,136
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,961
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- goose1127 September 2010
Heater Delete
-
Help. I'm looking for the round (firewall) heater delete plate for a 1960 catalina. I could probably make a homemade die and press one out, but trying the easier softer way first. Any help would be greatly appreciated.
Thanks -
having one made is really cheap and easy... go to any recycling place, here in Idaho I went to pacific recycling, I took in the measurements I needed for the floor plate and told them what I needed, they cut it for me all I had to do was take it home and drill the holes and spray some undercoating on it out of a rattle can. Grand total $5.50 for the metal, and about 15 minutes of my time.... Hope that helps. (sometimes we look in the most obvious places)
