Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,060
- Orphaned Marques
- ↳ Hudson21,130
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Geoff C., N.Z. August 2010
- stev1955 August 2010
1931 Essex Driveshift
-
Can someone tell me how to remove a driveshift out of a 1931 essex from the rear-end & from the tranny????
-
Just unbolt it and it will fall out! There are 6 bolts at each end holding hte flanges on.If you're stuck in a hole, stop digging.
-
Maybe you're having trouble like I had on my 30. The slip joint on the front yoke of the driveshaft was dry and corroded and when I removed the bolts the driveshaft flange just fell down on the nut on the transmission flange shaft. I had a time trying to pry the two apart before the driveshaft flange would clear the nut and fall away.Steve
1930 Essex Super Six
