Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,071
- Orphaned Marques
- ↳ Hudson21,138
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,962
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
49 Hudson Super Six 4-Dr. Rocker Panels Needed
-
I am in need of rocker panels for my 49 Hudson Super Six 4-Dr. My restoration is slowing until I find these parts. Does anyone know where they can be found?
-
Unfortunately, this is going to be a problem. There are a handful of NOS ones out there but you may have to find a used one an do a bit of improvising. Or get a good sheet metal man to bang one out for you. A company (Green Mountain) was making repro's but I don't think they are anymore, and even so, the curve is compound so I'm told they never really looked correct.
-
I did try Green Mountain and the phone number has been disconnected.
-
I guess the reason the phone number was disconnected is because I was given the wrong number. Duh!
I will try again on Monday. -
I think Jim Harmon will have a set , I'll call him for ya.
-
sent a you a PM
