Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,194
- Orphaned Marques
- ↳ Hudson21,250
- ↳ Street Rods808
- ↳ Off Topic569
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash71
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company959
- ↳ Chrysler Corporation478
- ↳ GM Corporation1,397
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,967
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- velomech April 2009
begining biuld of 51 merc
-
I have aquired a 1951 mercury and it is in need of some body panels like floor front rear and trunk, rockers, rear quarters the usual after a few years in the yard. I am having a tough time finding any companies that reproduce 51 mercury body parts it seems to stop at 50. Am I out of luck or does anyone out there now of any company that has started producing panels for this year mercury. I have looked on line and everything seems to take me to a ford and thats it. Unless these specific panels can be interchangeable but I doubt. I could be wrong. any help would be greatly appriciated by anyone. Thanks
P.S. Where would I need to go to decode the VIN number to identify original style, engine size, etc....? -
should be a 255 flattie.
715-537-5422 Classic Fabrication-for the merc floor pans is worth a shot.
My dad had a 51, I think they used the same stuff as the 50.
HTH, but this board is NOT frequented enough be a huge benefit. Im hoping that changes. I need help for my fairlane...
cheers and beers
hodge -
send an email,,i can put you in a good direction..merc in subject line
