Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,070
- Orphaned Marques
- ↳ Hudson21,138
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,961
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Oldcar_Mechanic December 2008
- paulrhd29nz January 2009
Ford 223 CID Inline 6
-
Complete Engine Block Rebuild with a mild performance cam.
Bored .030 over and Balanced.
Complete Cylinder Head Rebuild.
Compression Ratio is 9.8 to 1. Stock was 7.4 to 1.
Clifford Aluminum Intake with a Holley 350 CFM 2 BBL
Clifford “shorty†Truck Headers w/ VHT 1500 Ceramic Paint.
Clifford X-pipe to balance duel Flowmaster exhaust system.
All improvements probably added 50 HP to the stock 135 HP…
Not a lot of total horsepower, but moves the truck well with the air conditioner on.
Engine Finished Compressed_122924031551789.jpg448 x 336 - 28K
Header Side - 2 Compressed_122923606751789.JPG448 x 299 - 24K
Top Compressed_122923996651789.jpg448 x 336 - 28K
Engine - Installed 02 Compressed_122924396051789.jpg448 x 336 - 32K -
Nice job, looks good.
Ron -
great job. Can you let us know where you got the headers and intake from. Thanks
