Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,073
- Orphaned Marques
- ↳ Hudson21,138
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,962
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Oldcar_Mechanic August 2008
- STEVE1103 August 2008
Wiring of computer
-
Have a 3.1, 91 Camaro engine in a 47 Chevy, will start as soon as I get the gas tank refitted for fuel injection, its has been wired and fuel lines have been put in.What do I do with all the other wiring I am not using? Might have to use the dash wiring, but how will I get the my gauges to work, there is a ciruit board dash cluster for the Camaro? Looks like there is about a mile of wire still hooked to this engine! :confused: Thanks!
-
I don't believe that you will be able to connect the wires to your existing gages. Signals are sent for a digital gage.
Not totally sure on this but you could try talking to one of the guys at a place like painless and see if they have any info. Possibly a convertor?
Ron -
Thanks, have talked to many people about this, no one has given me the answer as yet, the older the car (computer) the less you can eliminate, I have figured out so far!:confused:
