Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,199
- Orphaned Marques
- ↳ Hudson21,255
- ↳ Street Rods808
- ↳ Off Topic569
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash71
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company959
- ↳ Chrysler Corporation478
- ↳ GM Corporation1,397
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,967
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
46 Hudson inner rear wheel seal
-
Does anybody have a current number for the inner wheel bearing seal for my 46?
Or
Does anybody have a pair of them they would like to sell me?
Thanks
EssexAdv@comcast.net -
Lew, The part I believe you are looking for was Hudson part #150066, origionally a leather lipped seal made by National.. This part goes back to 1936 and right on through the end of Detroit production. The replacement for this is Chicago Rawhide{CR} 17310. Carquest has it listed as 473010N. I think if you can still find National it may well go under the same number. Cost is about $8-10 ea. The dimensions were approx: 1.750" I.D. X 2.437" O.D. X .250" thick.
-
Thanks HudZulla. I checked out the seal you mentioned yesterday and it looks like it it the outer seal. What I need is the inner/axle seal. Any ideas?
Thanks
Lew -
The inner seal is part number 5811. Dale Cooper carries that part, for $12 each. See catalog at his website.
http://www.hudsonmotorcarco.com/
Jim Harmon in Banks Oregon carrys them also Phone # 503-324-7041. -
Dale does not have them. Any other thoughts?
-
Lew, Can you get the dimensions?
