Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,071
- Orphaned Marques
- ↳ Hudson21,138
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,962
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
WILCAP Adapters
-
Has any one here or know someone that has installed the WILCAP block to trans.adapter on a 48-54 Hudson Engine? When using the 55-56 crankshaft and a 200R-4 GM. trans. They sell a complet kit and any info would be of help .
Thanks to all Rudy. -
Rudy,
I have inquired on a Wilcap adapters in the past but ended up using an adapter from Dany Spring and another from Randy Maas and both are excellent. Dany's uses a 3/4 alum plate with dual bolt pattern while Randy's adapter went over the front pump with the Hudson bell. I think Randy will build to either crankshaft but (I think) Dany still has adapters on the back burner at this time. Chuck -
Thanks Chuck, I will contact both. Hudsonly Rudy
