Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,062
- Orphaned Marques
- ↳ Hudson21,132
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Scatedemon June 2007
- Steve E. June 2007
- Turbopackman June 2007
Packard Lug Pattern
-
Whats the lug pattern on a 1956 packard executive? 5X??
-
Steve E. wrote:4 3/4" same as Buick, Pontiac, Olds, Cad. The Clippers used the same pattern as Ford, Plymouth, Dodge, Hudson, etc. 4 1/2"
Thank you very much, i wasent around to car to check -
Keep in mind that the center hole is larger than most of those cars listed. I found that out the hard way.