Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,052
- Orphaned Marques
- ↳ Hudson21,122
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Don C. Mozynski March 2008
- super651 March 2008
Distributor seal.
-
We have a new Nitrile (buna-n) seal for the 232-308 engine dist.shaft.
It is a D-Ring design (not an O-Ring type) and has the proper crush on the D-Shape to STOP the OIL LEAK. (U.S.A. made )
The price is 1.90 each ,so order a few at this price.
Thanks to all. rbennett37@sbcglobal.net for the address -
Here I go, ressurrecting an old thread...
I have tried to contact super651 to get ahold of the D-ring seal for my leaky distributor, but have not gotten a response yet. Does anyone know of another source? I replaced the O-ring I found on the distributor with a like O-ring, but the leak persists. Maybe i didn't get it to seat right? Any help would be appreciated! -
Don, just sent you a PM. tHANKS RUDY
