Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,062
- Orphaned Marques
- ↳ Hudson21,132
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- `Hudsonator June 2007
- Clutch guy June 2007
- EssexAdv June 2007
- Fred Connors June 2007
- Glenn 52 June 2007
- Nevada Hudson June 2007
- Steve E. June 2007
52 - 54 OD needed
-
A long time HET member in my Chapter is in need of a good rebuildable 52 - 54 OD. His car is currently OD equipped but there a few concerns which make rebuilding it a less than desirable undertaking.
This transmission mut be rebuildable or useable as is...no junk. (if he wanted junk I would give him one I have here)
Please let me know what you can do
EssexAdv@adelphia.net -
Call Jim Harmon @ 503-324-7041 he has many good used gear boxes. I have a 52-54 transmission with O/D that has new bearings and seals installed. The price is $400.00 plus shipping - we both live in the North West.
-
Try Lester Harris at (775) 267-2559 In Minden Nevada. Has real good prices!
-
I am the one looking for the Hudson (52) T-86-E1A transmission dual lever and overdrive in good usable condition. I understand you may have one for $400 plus shipping that has new bearing and seals already. I assume the gears and main drive shaft and internal parts have acceptable wear.
When and how would you ship it to the east coast? -
Does anyone have a good source of parts for the OD units? Such as the rollers and other misc pieces that are in the OD.
Also, I have not been successful in finding input shaft needles that fit correctly (too long). Synchros, bearings, snap rings, and the wear plates for the countershaft I have found - but that's all.
MarkGimme a Hudson, with that "Instant Action" -
`Hudsonator wrote:Does anyone have a good source of parts for the OD units? Such as the rollers and other misc pieces that are in the OD.
Also, I have not been successful in finding input shaft needles that fit correctly (too long). Synchros, bearings, snap rings, and the wear plates for the countershaft I have found - but that's all.
Mark
Mark,if you need parts for the T-86e trans.,you can call Northwest Transmissions.I believe they are in Michigan.Also,you can try George Bachleda[OlCar bearing co.]in S.C..
