Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,073
- Orphaned Marques
- ↳ Hudson21,138
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,962
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- 52 kahuna January 2007
- 54Hollywood January 2007
- bill a January 2007
- Dave53-7C January 2007
- Nevada Hudson January 2007
- PAULARGETYPE January 2007
Radio repair
-
I seem to recall reading on this forum that Steve Engel repairs Hudson radios. His listed phone number in the Club Roster is disconnected. Does anyone have his correct phone number or should I try contacting someone else? Thanks for the help.
Tim in WI. -
I'm not positive, but I met a guy at a CIC tech session a couple of months ago, that I think was introduced as was Steve. (My computer isn't the only thing around here with memory problems.) Where was I.... oh yea, I think he hangs out a little with Bill A. You might give Bill a call, he can probably put you in touch with him.
Terry -
Here In Pittsburgh We Have A Raido Guy Who Works On Nothing But Tube Type Stuff He's Good Cheap And Gets Orignal Vibrators To Work Again Or He Will Ionstall A New Solid State One For You It Cost Me $125 And Thats With A Solid State Vib.
-
Found a neat place in Hemet California while on vacation. It's Called "Dick's TV Center, INC. 130 North Carmalita Ave. Hemet, California (951) 658-5018 www.dickstvcenter.com ; I'ts like a time warp in there! Many radios in there from the 20's to the 60's ! Dick has been repairing tube radios for over 50 years! I asked him if he can work on Hudson car radios, and he replied, " Sure, I remember them. I have lots of original tubes for them ." His prices are very reasonable.
-
Nevada Hudson wrote:Found a neat place in Hemet California while on vacation. It's Called "Dick's TV Center, INC. 130 North Carmalita Ave. Hemet, California (951) 658-5018 www.dickstvcenter.com ; I'ts like a time warp in there! Many radios in there from the 20's to the 60's ! Dick has been repairing tube radios for over 50 years! I asked him if he can work on Hudson car radios, and he replied, " Sure, I remember them. I have lots of original tubes for them ." His prices are very reasonable.
I wonder if Dick's TV has vibrators??? :rolleyes: -
Steve Engel, Het Radio Tech New No 909 5436678 Highly Recommended Bill Albright
-
Gentlemen:
Thanks very much for your replies to my post! When we bought our '54, it only had an aftermarket radio in it. I bought a correct radio from Stu Coleman but I need to get it working. Thanks to all of you, I now have some great resources to "git 'r done"!
Tim in WI -
correction on steves phone no 909 543 6078
