Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,194
- Orphaned Marques
- ↳ Hudson21,250
- ↳ Street Rods808
- ↳ Off Topic569
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash71
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company959
- ↳ Chrysler Corporation478
- ↳ GM Corporation1,397
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,967
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
Stabilizer Link Kit
-
Does anyone have a modern part# interchange for the stepdown stablizer link kits? One that could be obtained locally, such as NAPA? Thanks, Scott
-
5433HET wrote:Does anyone have a modern part# interchange for the stepdown stablizer link kits? One that could be obtained locally, such as NAPA? Thanks, Scott
Scott,
Don't know the NAPA number, but if you can, I'd suggest you call Dale Cooper. You'll probably have your parts within a few days. Plus, you'll be certain they're right, and for a good price. -
hudsonguy wrote:Scott,
Don't know the NAPA number, but if you can, I'd suggest you call Dale Cooper. You'll probably have your parts within a few days. Plus, you'll be certain they're right, and for a good price.
This is a good opportunity to go with urethane. Will improve the handling and will last forever. K-Gap has them or you can match yours up with the Energy Suspension catalog like I did for my 54. If you want I can pull the numbers when I am home. I believe the bar is 3/4 so all you need is a set of generic 3/4 diameter center bushings and I think I got the 7 1/2 inch end link kit from them. Comes with new bolts washers and bushings. I think the whole deal was around 30.00. -
464Saloon wrote:This is a good opportunity to go with urethane. Will improve the handling and will last forever. K-Gap has them or you can match yours up with the Energy Suspension catalog like I did for my 54. If you want I can pull the numbers when I am home. I believe the bar is 3/4 so all you need is a set of generic 3/4 diameter center bushings and I think I got the 7 1/2 inch end link kit from them. Comes with new bolts washers and bushings. I think the whole deal was around 30.00.
Thanks for all the info. I ordered the link kit from Dale, but would like to replace the rubber cushions with urethane if you can tell me what I need to do that. Scott -
For stabalizer links for stepdowns chaeck out 78 up GM Malibus ,Regals, Grand Prix, Cutlass Supreme rear wheel drive link kits I believe the spacer bushing are the correct length. Available at local parts suppliers
Jim Spencer
