Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,031
- Orphaned Marques
- ↳ Hudson21,103
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors148
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,958
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
6v to 12v push button starter solenoid
-
what soleniod for a dash push button starter switch?
-
The soleniod doesn't care whether it is key actvated or push button. You just have to run a hot wire to the button and a wire from the button to the start terminal on the soleniod.
-
the problem is only one wire to the starter switch. and it is to ground. it's on a 38 ford that has been converted to 12V keeping the 6v starter. the soleniod that was on the car worked fine, the starter went out, i thought it was the solenoid so i replace it . by the time i got the starter back from being rebuilt i had thrown away the soleniod thinking it was the same as a mustang. now i can't find a solenoid that works by grounding it. thanks for your reply
