Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,074
- Orphaned Marques
- ↳ Hudson21,141
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,962
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
Oldsmobile 350 Engine
-
I am in the process of rebuilding a 350 olds engine. Its time to put the crankshaft in. I am using the old rope type rear main bearing seal, and I am not real sure how to do it. I could not find a neoprene rear seal for it. How do you pack the rope seal in the block? Also how much of it do you cut off and with what? What do you use to pack the seal in the bearing cap with and do you use any kind of silacone sealer?
