Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,057
- Orphaned Marques
- ↳ Hudson21,127
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- dummy March 20
- Hudzilla March 21
- J Spencer March 24
- Ken U-Tx March 30
- Nevada Hudson March 19
- RL Chilton March 20
- ski4life65 March 30
- Tallent R March 21
- walts garage-53 March 19
Looking for Turn indicator dash light for 1951-53 Commodore or Hornet
-
Hello, I am seeking that little turn indicator light lens for the left side of the dash for a 1951 Commodore. I have the bulb holder and socket that goes on the back of the dash, but not the little lens and lens holder that the bulb holder clips over and is held in place by the spring loaded prongs built into the bulb holder. Thank you! Kenneth

DSC02212.jpg960 x 720 - 121K
DSC02211.jpg960 x 720 - 136K -
Try Hudzillla.
-
Ken, I have the piece but through the years the little yellow lens fell out. E-mail me ,Walt.
-
Lance-
If Ken doesn't want it, I do. E-mail me at: HETrlchilton52@gmail.com or call me. -
Before selling to anyone, I have to say that none of these have the 'jewel' on the part that shows on the dash. You likely can produce pone of these yourself from red film or amber film but again, mine don't have them.If that is not a problem, contact me at HEThornetllw@yahoo.com Drop the HET.
-
I had no idea these were hard to find. Did any other companies use these? I hate to say it, but I have probably parted out a few cars and didn't get these parts. I am not sure I have one for the 52 I am working on.
-
Did some digging and found an extra one. I have no idea what the install tool is that Lance is talking about. Ken, if you still need it, let me know.

IMG_0439.JPG3264 x 2448 - 3M
