Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,073
- Orphaned Marques
- ↳ Hudson21,138
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,962
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- dougson February 11
- GrimGreaser February 12
- hudnut52 February 11
- ski4life65 February 11
Need 1 hydraulic lifter, cam possibly.
-
Pulling apart my 56 motor, I find the #1 ex lifter has a chunk busted off the cam face. That cam lobe has been worn down about 0.08" too, to ~1.47". It's a bummer too, the cam, bearings, and other lifters look great otherwise. I have my lifters and cam from my original 52 motor, not out yet, I could use. But was looking forward to hydraulics... Anyway, someone willing to part with a single hydraulic lifter? Good used cam? Probably not recommended to run the 52 cam with hydraulics, huh?Six in a row makes it GO!
-
I didn't realize that was a 56 motor (thought it was a 55). Were you able to get the broken bolt out? What number is on the cam?
-
So did I till I got after the valve covers. Haven't gone after the bolt yet, been hitting it with penatrant. I think the cam has the 'common' number- 309742 - if I remember right (not in front of me). Looks like the lifter was bad from the factory, the way it broke.
So far so good, looks really good so far. Other than the lifter/cam issue.
IMAG0248.jpg1952 x 3264 - 2M
IMAG0250.jpg1952 x 3264 - 2MSix in a row makes it GO! -
You need the lifter body, not the hydraulic plunger. Aren't all the lifter bodies the same? Maybe not.
-
HI, GRIM GREASER , THIS IS HUDNUT52 FROM WISCONSIN I HAVE A 52 HORNET SEDAN WITH HYDRALIC LIFTERS AND THE 309742 CAM IN IT. I DO HAVE SOME LIFTERS I WOULD SELL YOU AND A CAM I DO NOT KNOW CONDITION OF CAM
-
Eh... The more I think about it the less I want to mix-and-match so to speak. I'll probably run my set from the 52. Unless I can find a matching set that's been kept track of.Six in a row makes it GO!
