Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions26,920
- Orphaned Marques
- ↳ Hudson20,986
- ↳ Street Rods798
- ↳ Off Topic556
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash71
- ↳ Packard163
- ↳ Studebaker121
- Classic American Cars
- ↳ Ford Motor Company959
- ↳ Chrysler Corporation478
- ↳ GM Corporation1,394
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,961
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Geoff C., N.Z. December 2012
- kamzack December 2012
- walts garage-53 December 2012
hudson 8 valve lash ?
-
Lookin for the valve clearance on a 51 str8 8?
-
I'd suggest sending an email to Dr. Doug at Wildrick Restorations Address is on his website.
Kim -
.008" inlet and .010 exhaust, with engine hot.If you're stuck in a hole, stop digging.
-
Make sure you use a new gauge after you set 4 valves for then they are pounded out of shape and you will have tight valves. Best way is cold set at 12 and 14. Walt.
