Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,079
- Orphaned Marques
- ↳ Hudson21,145
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,963
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
Getting to the bottom of my gearshifting problem
-
At last I've found the time to take the transmission out of the '34 Hudson to try to sort out why I can't get it into gear.
I can't find the following information in the Mechanical procedure Manual -
1. How far along the shaft should the thrust bearing assembly be moved by the fork ?
2. How far from the surface of the pressure plate should the clutch fingers be when at rest ? Mine are 37mm, 39mm and 40mm - shouldn't they all be the same distance from the plate ?
Can anyone fill me in, please ? -
Calling Dr. Doug ... Dr. Doug wanted in the emergency ward!
-
I do know the pressure plate fingers should be all the same height. Doug W will know the dimensions in question.
