Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,031
- Orphaned Marques
- ↳ Hudson21,103
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors148
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,958
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Park_W November 2012
heater hose config.
-
trying to hook up heater hoses. what is the way to hook up from bypass to heat control to heater core . hooked it up to what i thought would work , but when i ran engine it started to blow water out overflow tube . any ideas would help
-
OK, there are two sets of connections ... the ones that are side by side are for the heater valve, the set that are "over-under" are the heater connections. For the connections of the heater (Ranco) valve, the right-hand one connects to the cylinder head outlet; the left one goes over to the lower connection on the heater. The upper connection for the heater goes up forward to the water pump.
