Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,059
- Orphaned Marques
- ↳ Hudson21,129
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- SuperDave March 2005
Seal for 55 Hudson Power Steering Cylinder
-
I am looking for a source for the seal that goes around the output shaft of the power steering cylinder for a 55 Hudson Hornet. The seal is called a "T" seal and it has fiber support rings that go in each side of it to support the "T". The "T" seal fits in a groove that is 1" in Dia. and 3/16" Deep. I found a source of this seal from Parker Hannifan. It is part # 4115-B001-TR010. The trouble is so far I havent found any source that has this seal available. I did find out that Parker Hannifan only sells them in lots of 25 minimum at about $6 ea. Thanks for any help or advice. Rob
Cropped%20T%20seal_111001612646400.jpg320 x 240 - 22K -
Rob,
I am not familiar with the 55, but have recent experience with a 54.. Similar? I had my cylinder and valve rebuilt by www.larescorp.com . They were not cheap, but actually remanufactured mine with a new piston. Perhaps they can be of help obtaining the part you need. it wouldn't hurt to give them a try. Check the web site and send them an email.
Good Luck, Dave
