Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,081
- Orphaned Marques
- ↳ Hudson21,146
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,963
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- MikeWA September 2012
- Pacemaker500 September 2012
O/D Wiring Help @ Relay, please
-
I lost the pictures I took of the O/D Relay wiring. So now I need help in figuring out which wire goes to which pin on the
Relay. I am having to go with push-on spade terminals since I can't locate a replacement plug end.
The Service Manual I have shows a six wire connector but I only have a 4 wire.
I do know that the single wire from the Governor goes to the angled spade on the relay. And the spades are numbered 1, 2, 3, 4 on the Relay. -
Here's a diagram, if that helps.
hudsonoverdrive50-52.jpg629 x 518 - 69K -
MikeWA,
THANK YOU!!! This is NOT is the Service Manual I purchased. What manual is this from?
I can actually follow/trace the wires in the engine bay and figure it out now.
I have already found I had it wrong to start with. But the wires were all frayed cloth and I think they were shorting out before I took ownership.
