Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,062
- Orphaned Marques
- ↳ Hudson21,132
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Chris Smith August 2012
last ditch effort - '54 stainless
-
I'm preparing the '54 for paint and pre-mounting the trim so I can install it after painting without hassle. I have not been able to find a passenger side stainless piece. Any out there? I have a good stainless guy who can repair bends and polish.
Picture 002.jpg3264 x 2448 - 2M -
Call Val or Jason at Vintage Coach, they have drums full of stainless trim and is worth a phone call anyway. You should measure the length of the trim on the other door and give them that length. Its going to be 2 door specific, and right side specific, but I don't think its 54 specific as I used an earlier model door on my 54 and that trim piece was the same.
