Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,047
- Orphaned Marques
- ↳ Hudson21,118
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors148
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- 5433HET July 2012
- ArkieJazz July 2012
- Ken U-Tx July 2012
- walts garage-53 June 2012
308 Head Gasket Help!!
-
I was going to install my freshly milled and epoxy red painted cylinder head tonight on my '54 308.........but NOOOO..... while checking the gasket alignment on the head and block, I noticed a group of coolant holes did not line up with the gasket. Actually, every OTHER trio of these holes DID line up, in a repeating pattern. I believe this is an old replacement style gasket, and I did not want to install it until I heard some opinions! So please...... has anyone seen this alignment problem? Of course, it does not go away if I flip the gasket. The gasket is secured properly in all four corners to show actual alignment... AND... I no longer have the original gasket to compare. Thanks for any help!
Scott
holes 308.jpg3264 x 1840 - 859K
308 holes.jpg3264 x 1840 - 1M -
Are you sure you have a 308 head gasket? 262's from 48 to 1950 are narrow blocks and gasket will not line up on a 308. 51 up 232's and 262's are wide blocks like the 308 but gaskets will not work on the 308's. Get your gasket from Dale Cooper. Walt.
