Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,040
- Orphaned Marques
- ↳ Hudson21,111
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors148
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- 1049superg February 2012
- 56starfire February 2012
Oil pump alignment tool for sale
-
Here it is by popular demand (ha ha) a revised version of the stepdown 6 cyl alignment tool to set the oil pump gear in sync with the distributor. This is a reproduction tool in aluminum. Cost is $30 plus $11 for shipping. I made some changes from the original KM tool I borrowed. With the original you are trying to align the tool offset tab with the oil pump gear both inside the body of the block - blind essentially. This tool is longer so you can see and move the alignment pieces out in the open. Also I have no decorative knurling and less different diameters on the tool - all unnecessary. If you have questions email me at: HETgtkristi@copper.net (delete the HET)
Gert Kristiansen
1731 S 500 E
Salt Lake City, UT 84105
P.S. your personal check is fine. Thank you for your interest. -
I may never need one of these again, but just to have had it in the past would have saved me a lot of trouble. I'll be sending you a check for one. Thanks for reproducing this nearly impossible to find tool! Dan
-
Just send you a check for your alignment tool
Thanks -
Me too!
