Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,072
- Orphaned Marques
- ↳ Hudson21,139
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,962
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- andarius February 2012
- dave s February 2012
- dougson February 2012
- rambos_ride February 2012
- RonS February 2012
Twin H Carb spacers
-
Does anyone have a good source for Carb spacers for a Twin H? I need to bring mine up a little under 1/2 an inch.
-
NAPA, Take an original and they can match it up with a Ford gasket
-
Try felpro 60269 for a Ford just a tad under 1/8" each. I had to ream the holes a bit to place over the studs, no biggie.
-
Thanks
-
Rochester Monojet (GMs) or Carter YF used in MOPARS used a thick base gasket.
-
I think you're looking for the backlite type spacers, you would still need 3 thin gaskets with this and the heat sheild.
Rochester Carburetors
CHEVROLET 1932-52
Throttle Body Parts
Delco 3692799
http://www.chevsofthe40s.com/shop/search.lasso?search=+3692799+&searchtype=FT&Go=Go&year=All&dept=car
