Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,062
- Orphaned Marques
- ↳ Hudson21,132
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- cargray January 2012
- EssexAdv January 2012
- faustmb February 2012
- walts garage-53 January 2012
254 Camshaft
-
The #1 Exhaust valve is only lifting about half what it should on the 254 eight I'm rebuilding. Bummer!
Anybody got a good camshaft, or a good place to get it fixed?
Thanx
HETcramerlp@roadrunner.com (minus the HET) -
Larry, I think I gotr my re-ground from Bob Rivigno in NJ....
-
Remove the lifter before you do anything else, to see if the bottom is worn away. This is what the lifters do in a splasher engine. We have a company that makes new lifters, do not have them refaced as they drop so low you can not adjust the clearance. Walt.
-
Try Al Saffern in Ariz. He is in the WTN Bet he has a good cam and can supply reground lifters...I have never had a problem with adjusting reground lifters.
-
Larry, I may have a good cam. Let me know if you still need one.I'll check the casting number.
