Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,052
- Orphaned Marques
- ↳ Hudson21,122
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- RonS December 2011
Hood Brace
-
What kind of material should be used between the hood cross brace and hood. I was able to remove original asphaltic type material intact, but would like to replace it with something that looks a little better.
Thanks in advance,
Kim -
I use rubber sheets cut to size. The thickness will depend on the space between the hood sheet metal and the brace. Ace hdwr has 'em. A bit of contact cement is a good idea also.
