Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,062
- Orphaned Marques
- ↳ Hudson21,132
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Uncle Josh December 2011
fenders??
-
I have to reform my fenders, There alittle bang up near the bottom, & top and the shape is off abit. Would an english wheel bring them back to the proper shape
Thanks George
[attachment:2]C:\fakepath\IMG_0228.JPG[/attachment] -
I just did a 40 front fender that had been hit in the side over the wheel. I determined the good one was about a 6 in radius. Cut a 1 ft dia block of wood from a blowdown, put it on the horse under the fender and beat it into shape with a rubber hammer. Suprised me. I still had dents I had to beat out and Bondo, but the basic shape was there.
