Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,068
- Orphaned Marques
- ↳ Hudson21,136
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,961
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- BJ__TN November 2011
Stepdown Roof mount antenna removal?
-
I'd like to remove the antenna from my car for painting, but I can't seem to get the plastic bezel that's under the knob off. I don't want to pry on it much because the old plastic is so brittle. I there a trick to getting it off?
Mark R.
Oregon -
Mark, You need a deep well THIN Wall 11/16ths socket. there is a nut inside the plastic housing that must be removed before the bezel can be removed. It MUST be a thin walled socket or it will not fit without breaking the bezel.
Bob Hickson
