Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,045
- Orphaned Marques
- ↳ Hudson21,116
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors148
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- oldhudsons October 2011
Door Panels
-
I need to get the door panels off my 39 Hudson six but not sure how the window crank handleof the door handle come off. Any ideas?
-
you have to push in hard on the escutheon plate & between it & the handle itself you will see the handle's shaft with a small pin holding the pin to the door mechanism. I've usually found using a nail, which is about the correct diameter, will push it through BUT you'll probably have to use a hammer to do so. Sometimes this operation, since it's usually hard to push the escutheon in far enough & at the same time try to drive the pin out, requires 2 people.
