Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions26,920
- Orphaned Marques
- ↳ Hudson20,986
- ↳ Street Rods798
- ↳ Off Topic556
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash71
- ↳ Packard163
- ↳ Studebaker121
- Classic American Cars
- ↳ Ford Motor Company959
- ↳ Chrysler Corporation478
- ↳ GM Corporation1,394
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,961
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Hudson308 October 2011
- kamzack October 2011
- Richard E. October 2011
Canvas Splash Guards
-
Is there supposed to be a metal strip run through the pocket of either top or bottom of the canvas splashguard? When I took my car apart there was rements of canvas and a thin piece of metal through what was left of the fabric. I'm asking cause I only have on piece and would like to have another for the other side. I'm thikin what I have is driver's side as passenger has most corrosion.Strip is about 3/4" wide and is configured to the contour of the bottom of the inner fender panel.
Kim -
Yup... there should be a metal strip in there for weight to keep it from sailing. It should be the same size on either side.Workin Stiff
-
Thank you,I thought so. Is there one out there someone would part with?
Thanks in advance,
Kim -
You can get the new canvas from K-Gap!
-
I have the canvas, need one metal strip.
Kim
