Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,052
- Orphaned Marques
- ↳ Hudson21,122
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Aaron D. IL September 2011
Sweden hornet update wiring harnes
-
Maybee you have follow my Sweden Hornet Update .Now i´ts time to do new wiring harnes to my sedan at the same time i gone convert it to 12 volt but all my old harnes is in bad condtion so it hard to see . I make the new harnes after the Wiring Diagram in the part book but there is no diagram over the director indicator there are a block there the dir ind. lever harnes go but i dont know who others wiring to connect .
Can somebody help me is there any wiring diagram avelible for the dir. ind . ?
and i be glad if i get tip of 12 convert.
Jan Pettersson Sweden -
Jan the wiring diagram in the shop manual does not include the wiring for the turn signals because they were usually added on aftermarket even if done by the dealer. If you look up "SIGNAL-STAT wiring diagram" in google I think you can locate a wiring diagram that is just for add-on turn signals. It should be accurate but if not you may have to look up instructions/diagrams from the turn signal manufacturer.
