Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions26,920
- Orphaned Marques
- ↳ Hudson20,986
- ↳ Street Rods798
- ↳ Off Topic556
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash71
- ↳ Packard163
- ↳ Studebaker121
- Classic American Cars
- ↳ Ford Motor Company959
- ↳ Chrysler Corporation478
- ↳ GM Corporation1,394
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,961
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
Starter woes
-
Replaced what I believe is a 51 Nash 6 in my 50 Nash. The flywheel is different than the one from the engine I removed. The ring gear is recessed about 1/2" where the one I removed is almost flush with the front. The starter will not work . Also, the one I pulled out has 5/8 screws whereas the one I put in has 3/8 studs, so I have to use the recessed flywheel. Can anyone Identify the motor with 3/8 studs on the crank so I know what kind of starter to get? Thanks, Jim
