Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,033
- Orphaned Marques
- ↳ Hudson21,105
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors148
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,958
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- chopperchuck September 2011
- Marconi September 2011
Steering Wheel Puller?
-
Does anyone have a steering wheel puller I could rent for a stepdown? This is the last step in my conversion from Hydramatic to manual w/ OD
Phil - Austin -
Try a NAPA store. They may not rent them but they're not too expensive either.
-
i've never really looked at my steering other than to notice that it's falling apart,but i have used/& [still have] a plumbing seal puller that i bought for less than $6 at ace hardware,it's a straight slotted bar W/a pretty long push of bolt.you might also try harbor freight they had a cheap set for something like $12.oo.....hell if ya have some scrap 1/4 plate & welder & drill -make your own.Have you kissed a PIT BULL lately?
Greeley Colorado
