Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,195
- Orphaned Marques
- ↳ Hudson21,251
- ↳ Street Rods808
- ↳ Off Topic569
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash71
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company959
- ↳ Chrysler Corporation478
- ↳ GM Corporation1,397
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,967
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- DocHornet September 2011
- Richard E. September 2011
- ski4life65 September 2011
Desperately Seeking Clutch Alignment tool
-
I'm ready to install my manual tranny with rebuilt clutch from Ron Fellows. Can't seem to find a source for a clutch alignment tool.
Does anyone have one they would sell or lend?
Phil@Auldridge.org 512 517-0055 -
Where are you located? Don't you have an old transmision laying around that you could pull the front shaft out of?
-
-
Thanks for that connection. Once I saw that the "store-bought" units don't have a splined shaft, I just measured the input shaft diameter and turned my own on the lathe
