Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,194
- Orphaned Marques
- ↳ Hudson21,250
- ↳ Street Rods808
- ↳ Off Topic569
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash71
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company959
- ↳ Chrysler Corporation478
- ↳ GM Corporation1,397
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,967
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- 47HUD August 2011
46 47 gas tank cut out location
-
Hi all,
I was wondering if any owners of a '46-'47 Hudson sedan could tell me the measurements of the gas tank cut-out on the trunk floor pan. I had the trunk floor replaced on my car but they never located the cut-out for the gas tank filler neck so now I have to cut the hole in the trunk pan.
Can anyone give me a measurement from the back edge of the trunk (from the inside) to where the filler neck hole begins???
This way I can make the cut-out myself. Thanks much. -
Aaron, sent you a private message regarding the dimensions for the fuel fill neck opening on the sedan trunk floor
47HUD
