Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,073
- Orphaned Marques
- ↳ Hudson21,140
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,962
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Lee ODell May 2011
Engine ID
-
Just bought a 1950 Nash statesman custom. The motor in it has a cracked block S350230. I also got 2 other motors with it. I'd like to make one out of the three. No. S22176 is the one I'd like to go with. It supposed to have only 30,000 miles on it. The last one I have is S83120 with a thrown rod. Going by the motors manual, it seems that the one in the car isn't the the original motor. Does someone have a rundown of these three motors, what ci. and year they are. Thanks, Jim
-
41Hud
1950 - 1951 are the same size - 184 C.I. Bore X Stroke 3 1/8 X 4 inches
1952 - 1955 are the same size - 195.6 C.I. 3 1/8 X 4 1/4
It appears in the Motors Manual the Rambler started useing the same engine in 1953. Mine is a 1961 manual and the Rambler is still using the same size engine.
The only engine numbers I can find are
1950 S92001
1951 S207001
Measure how far down the piston goes and that will tell you if it is an early or later engine.
Lee O'Dell
