Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,201
- Orphaned Marques
- ↳ Hudson21,257
- ↳ Street Rods808
- ↳ Off Topic569
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash71
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company959
- ↳ Chrysler Corporation478
- ↳ GM Corporation1,397
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,967
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
King-Seeley Gauges
-
Hi there can anyone help, I am wanting to Know the Technical Discription for the wire used in the King-seeley gauges I am told that the wire is Ni-chrome wire 36 gauge but do not know what the technical details are for the wire.It has to be wound on the BI-metal strip which has a sharp edge as per photos & the Insulation must be Heat Resistant. The Gauges are 6 volt and work by heating the Bi-metal strip. Points open and close continually to give the readout at the gauge. Hpoe you can help.Regards. J B Leech.
wiremountingpoints.jpg800 x 600 - 27K
DashGauge.jpg501 x 375 - 55K
