Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,069
- Orphaned Marques
- ↳ Hudson21,137
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,961
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
Door & quarter panel metal stiffeners
-
I had a friend bend some u shaped stiffeners to go on the bottom of the top half of the quarter panels does the top half of the door panel need these to mine were non existant except for the one I used for a patern. I also had my friend make the stiffeners for the bottom of the door panels that also hold the door panel against
the bottom of the door. I am working on a 54 Hornet Hollywood. Hudsonly Ray:woohoo:
