Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,065
- Orphaned Marques
- ↳ Hudson21,134
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,960
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- Jon B January 2011
- Ottobethere January 2011
Drive Shaft ( propeller shaft )
-
I would like to switch to an overdrive transmission in the 41 C6S and I know that I will have to shorten the drive shaft. I'm trying to find out if anyone is aware of the difference in the length of the transmissions between a standard and a overdrive. I have located different size hudson drive shafts, it's just a matter of picking the right one that will fit the overdrive transmission. Any ideas? Thanks.
-
I measured the drive shaft it is 56". Does anyone know what the length of the drive shaft is on a overdrive transmission between 40 to 47? Thanks.
-
You might want to put this question on the Hudson forum. Right now you've posted it out in the "lobby", so to speak.
